[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Linrad] Re: unicast
- Subject: [Linrad] Re: unicast
- From: Joe Taylor <Princeton.EDU; joe@xxxxxxxxxxxxxxxx>
- Date: Wed, 30 Jul 2008 08:13:19 -0400
Hi Alex and all,
> I try to run Linrad + MAP65 on the same computer with the network card
> disable as Ken did (I run Linrad under Windows XP), well Linrad runs
> perfect, MAP65 didn't start.
> I need to have the netwotk card enable and both runs ok with the network
> card linked to a insolated network switch. MAP65 didn't star if the network
> card is not active and linked with a network device such a Switch, hub etc.
> Good practice here to save the external switch was have two network cards on
> the same computer linked together with a "null modem cable", works fine.
If both programs run on the same computer, there should be
no need for any network cards at all. Both programs should
be able to use the IP address 127.0.0.1, a pseudo-network
address for local (memory-to-memory) transfers.
Neither Linrad nor MAP65 provides a runtime option to set
the network transfer address. These could be added, of
course. At present it is necessary to make some very minor
changes to the source code and re-compile.
See you in Florence, next week!
-- 73, Joe, K1JT
You received this message because you are subscribed to the Google Groups "Linrad" group.
To post to this group, send email to linrad@xxxxxxxxxxxxxxxx
To unsubscribe from this group, send email to linrad+unsubscribe@xxxxxxxxxxxxxxxx
For more options, visit this group at http://groups.google.com/group/linrad?hl=en