[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [linrad] Still problems svga
Success at last!
download source svga-1.4.3.tar.gz
copy to /usr/local/src
/usr/lib/vgagl.so.1 (copy- note vgagl is not at /usr/local/lib and the
links didnt seem to work)
(same for libvga.so.1.4.3)
I tried various linrad distros - rpm didnt work as it couldnt find libvgagl.
Eventually used the source
download bzip2 and install
download linrad01-15 and copy to working directory
bzip2 -xf linrad01-15.tgz
tar -xvf linrad01-15.tar
etc as in instructions
Many thanks for your patience
Now I can start learning all the intricacies of FFTs etc - fascinating!
I have a DDS board using the AD9854 which can give quadrature output to
60 MHz or so.
I will set up a direct conversion I/Q frontend using a "Tayloe"
architecture with the FST3125 quad switch and a couple of opamps.
I ignored the errors and in fact libvga and libvgagl were in a different
Sigurd Kimpel wrote:
>My experience is that I could not get svgalib-1.9.x to work, but
>svgalib-1.4.3 would work.
>----- Original Message -----
>From: "Richard Hosking" <richardh@xxxxxxxxxxxx>
>Sent: Sunday, February 29, 2004 5:56 AM
>Subject: [linrad] Still problems svga
>>I am still struggling to get svga installed
>>I have tried svgalib-1.4.3 and svgalib-1.9.18
>>gcc seems to generate various errors when it includes various files from
>>the kernel and main.o will not compile.
>>I have tried this on Mandrake 9.2 and RH9.0 and two different machines -
>>kernel 2.4.22 and 2.4.20
>>Also there was a linker error - ldconfig in the makefile was not
>>Has anyone done svga with these latest distros? I am thinking that there
>>may have been kernel changes since the last version of svga
>>I could go back to RH 8.0 or even 7.2 if necessary, but this will be a
>>Thanks for your patience - at least I am learning something about the
>>nuts and bolts of Linux!