[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: [linrad] Still problems svga
May I ask where you acquired your DDS board?
[mailto:owner-linrad@xxxxxxxxxxxxxxxxxxxxxx]On Behalf Of Richard Hosking
Sent: Tuesday, March 02, 2004 10:31 AM
Subject: Re: [linrad] Still problems svga
Success at last!
download source svga-1.4.3.tar.gz
copy to /usr/local/src
/usr/lib/vgagl.so.1 (copy- note vgagl is not at /usr/local/lib and the
links didnt seem to work)
(same for libvga.so.1.4.3)
I tried various linrad distros - rpm didnt work as it couldnt find libvgagl.
Eventually used the source
download bzip2 and install
download linrad01-15 and copy to working directory
bzip2 -xf linrad01-15.tgz
tar -xvf linrad01-15.tar
etc as in instructions
Many thanks for your patience
Now I can start learning all the intricacies of FFTs etc - fascinating!
I have a DDS board using the AD9854 which can give quadrature output to
60 MHz or so.
I will set up a direct conversion I/Q frontend using a "Tayloe"
architecture with the FST3125 quad switch and a couple of opamps.
I ignored the errors and in fact libvga and libvgagl were in a different
Sigurd Kimpel wrote:
>My experience is that I could not get svgalib-1.9.x to work, but
>svgalib-1.4.3 would work.
>----- Original Message -----
>From: "Richard Hosking" <richardh@xxxxxxxxxxxx>
>Sent: Sunday, February 29, 2004 5:56 AM
>Subject: [linrad] Still problems svga
>>I am still struggling to get svga installed
>>I have tried svgalib-1.4.3 and svgalib-1.9.18
>>gcc seems to generate various errors when it includes various files from
>>the kernel and main.o will not compile.
>>I have tried this on Mandrake 9.2 and RH9.0 and two different machines -
>>kernel 2.4.22 and 2.4.20
>>Also there was a linker error - ldconfig in the makefile was not
>>Has anyone done svga with these latest distros? I am thinking that there
>>may have been kernel changes since the last version of svga
>>I could go back to RH 8.0 or even 7.2 if necessary, but this will be a
>>Thanks for your patience - at least I am learning something about the
>>nuts and bolts of Linux!
This email and any files transmitted with it are proprietary and intended solely for the use of the individual or entity to whom they are addressed. If you have received this email
in error please notify the sender. Please note that any views or opinions presented in this email are solely those of the author and do not necessarily represent those of ITT Industries, Inc.
The recipient should check this email and any attachments for the presence of viruses. ITT Industries accepts no liability for any damage caused by any virus transmitted by this