[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: F3 for walking through recorded files
- Subject: Re: F3 for walking through recorded files
- From: "on7eh" <skynet.be; on7eh@xxxxxxxxxxxxxxxx>
- Date: Fri, 20 Mar 2009 21:13:06 +0100
A. I just tried F3 on your enclosed 03.04. (I copied adfile and adwav from
previous 03.03 version)
The responsiveness of F3 to stop the running .raw is maybe higher but still
Especially after several F3 tries. (F3 to fasten, F3 to normal, F3 to
fasten, F3 to normal speed)
I cannot think the command to stop an accelerated file is originating from
pushing "F3" alone. There seems to be another dependancy...
B. The indicated times of repeating .raw files (this is how I run it) are
now correctly reset from inintial time.
C. It looks like the "fasten speed" after F3 is varying from xx.raw file to
yy.raw file; sometimes quick, sometimes slow.
Is it dependant on the file size?
D. I confirm that when F3 is pushed that the loudspeaker stops and the file
The problem resides in the non-responsiveness of pushing F3 with a running
file, to stop the file.
To me it is fine enough but not optimal...
----- Original Message -----
From: "Leif Asbrink" <leif@xxxxxxxxxx>
To: "on7eh" <on7eh@xxxxxxxxx>
Sent: Thursday, March 19, 2009 11:01 PM
Subject: Re: F3 for walking through recorded files
I tried F3 on different raw files this evening. (03.03)
When I push on F3, I can see high speed wind forward action. THIS ALWAYS
However, when I push on F3 again, to go back to normal speed, by pushing
again, either Linrad :
1.immediately slows down (= immediate reaction after F3, this is
2.slows down after a longer period (some fractions of a second to one
or so (this time varies apparently but NO prompt reaction)
3. does not seem to react after some seconds so I push again F3 and there
will take either a long time or many tries to comeback
to normal speed. There is no indication whether the "slow down to normal
speed" command was received so one keeps pushing or wait...
The above is in line with the red square on the top left of the Linrad
I.e. the red square is always active with high speed wind forward, the
square always disappears with normal speed back.
What I wanted to know is if things go wrong as you describe here
also when you have selected a signal so you actually have
loudspeaker output when linrad runs at normal speed. F3 should
stop the loudspeaker and accelerate processing.
When no signal is selected I run into problems here. Not quite
as you observe though;-) Please try the attached file which
seems to run OK here.