[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Linrad 02-41
- Subject: Re: Linrad 02-41
- From: aol.com; stanka1ze@xxxxxxxxxxxxxxxx>
- Date: Fri, 18 Jan 2008 03:37:55 -0500
Good Morning Roger,
Thank you for the advise. I am still in the hotel and I forgot to install inpout32
. I am excited to go back to the shack in the morning and get 02-41 working. Thanks for your help and Leif, I hope I didn't cost you any loss of sleep! I'm sure this is just the beginning of operating errors in this weekends contest.
73, Stan, KA1ZE
From: Roger Rehr
Sent: Fri, 18 Jan 2008 12:10 am
Subject: Re: Linrad 02-41
Hi, Stan et al,
I just fired things up to check it out here.
On Windows XP the stock download of Linrad-02.41 runs OK and controls
the WSE OK with no strangeness.
I am using it on a Core 2 Duo machine running the 32 bit form of XP,
and my parport has address 33792 [0x8400].
I of course have inpout32 installed as well, to permit parallel port control.
I suspect that there was a problem with your compile, even though you
get no error message. Why not use the precompiled version of 02.41?
I'll bet it runs fine!
Will get it for you, and I suspect there will be no problems if you use it.
Also, would suggest starting in an empty directory...
> I tried exiting and reentering the program. The results are the same.
> I have no control of WSE hardware.
> -----Original Message-----
> From: Leif Asbrink <Thu, 17 Jan 2008 8:09 pm
> Subject: Re: Linrad 02-41
> Hi Again Stan,
> Maybe, if you start Linrad and run through the
> general parameters setup (screen, parport etc.) you
> would have to exit and restart Linrad to make your
> choices valid. Please try that and tell me if it works.
> Maybe I have to force an exit after running 'S'=Global.....
> Leif / SM5BSZ
>> I was unable to get 02-41 working with my WSE hardware. It uses
>> Parport 888 and Ack=10
>> I try to do Z=Hardware Test and the Linrad program shuts down.
>> This same computer works fine with Linrad 02-35
>> Stan, KA1ZE/3
> More new features than ever. Check out the new AOL Mail ! -
You received this message because you are subscribed to the Google Groups "Linrad" group.
To post to this group, send email to linrad@xxxxxxxxxxxxxxxx
To unsubscribe from this group, send email to linrad-unsubscribe@xxxxxxxxxxxxxxxx
For more options, visit this group at http://groups.google.com/group/linrad